Chemical Treatment and Recycling

Pollution prevention is intended to reduce, eliminate or prevent pollution at its source. Efforts towards pollution prevention at the UW include treatment by generator, universal waste management and recycling.

Treatment by generator

Treatment by generator refers to treating your own hazardous waste, which helps the UW avoid the risk and cost of hazardous waste transport and disposal.

By law, Environmental Health & Safety (EH&S) is required to report all hazardous waste treatment at the University. If treating waste, you are required to:

Have an approved procedure;
Document training; and
Keep an updated Chemical Treatment Log.

If you would like to begin treating any of the chemicals listed below, contact Environmental Programs and we can help you get started.

An acid or base may be neutralized and poured into the sanitary sewer only if the neutralized mixture is not toxic and final pH is greater than 5.5 and less than 12.

These acids and bases may not be neutralized and disposed of into a sanitary sewer:

Perchloric acid at any concentration
Nitric acid, concentrated
Sulfuric acid, fuming (concentrated)
Hydrofluoric acid (email chmwaste@uw.edu for information)
Acids or bases with high concentrations of metals or other contaminants
Acids or bases that contain dyes or surfactants
Any organic acids and bases that are still toxic after neutralization (most organic acids and bases; one exception is acetic acid with a concentration of less than 80 percent)

CIDEX® OPA is used commonly in hospitals and some research laboratories to disinfect medical and some research devices.

OPA (orthophthaldehyde) is highly toxic to fish. Therefore, waste CIDEX® OPA needs to be treated before it can be poured down the drain. The OPA concentration in waste CIDEX® OPA is usually about 0.3-0.5 percent, however the King County sewer discharge limit is 0.01 percent.

Many commercial products are available to treat CIDEX® OPA. Follow product instructions for treatment time.

Ethidium bromide is a nucleic acid stain. It fluoresces under ultraviolet light, especially when bound to double-stranded DNA. It is also a strong mutagen and a possible carcinogen, so must be managed correctly.

Aqueous solutions of ethidium bromide with concentrations less than 10 µg/L (10 ppb) are not considered hazardous and may be discharged to the sewer. Solutions containing greater than 10 µg/L (10 ppb) must be chemically treated or collected as hazardous waste.

We recommend GreenBags for treating dilute (over 10 µg/L) solutions of ethidium bromide. The treated water can be disposed of in the sink. The tea bags, which contain activated carbon, absorb the ethidium bromide so tightly that it is safe to put them in the trash.

We give a starter kit of three tea bags to each laboratory. Contact Environmental Programs to request them. You can buy more GreenBags from VWR via eProcurement. The product number is 100371-168, and a pack of 25 teabags costs about $90.

Gels that contain ethidium bromide may be doubled-bagged, labeled "non-hazardous" and placed in the trash if they contain less than 0.1 percent ethidium bromide. If the gel is pink or red, the ethidium concentration is higher than 0.1 percent. In this case, the gel is handled as hazardous waste.

Items contaminated with concentrated ethidium bromide are managed as hazardous waste. Pipette tips contaminated with dilute ethidium bromide are dried and placed into a lab glass bin. Other items contaminated with dilute ethidium bromide may be double-bagged, labeled "non-hazardous," and placed in the trash. Please double-bag to keep waste handlers from being exposed.

Formaldehyde, or formalin, is commonly used at concentrations near 3.7 percent in water to preserve specimens and samples. It also qualifies as hazardous waste when it is no longer needed. However, King County Wastewater Treatment Division allows us to discharge toxic formaldehyde to the sewer at concentrations of less than 0.1 percent. Therefore, formaldehyde must be treated to reduce its concentration before it is poured down the drain.

Treatment of formaldehyde in your laboratory is simple and easy. We currently recommend Neutralex or a similar product to destroy the formaldehyde. Use of Neutralex according to instructions will reduce formaldehyde concentrations to well below 0.1 percent.

More information

Visit the Chemical Waste Disposal page for information about disposing of chemical waste.

Universal waste and recycling

Certain types of dangerous waste can be handled under the simplified Universal Waste rules. The rules allow for much easier management than regular dangerous waste requirements.

Environmental Health & Safety manages a few categories of universal waste listed below.

Batteries cannot be placed in the trash because they contain corrosive materials and toxic metals.

University departments and units have two options for recycling used batteries.:

Less than 5 pounds: Place batteries in an e-Media bin. Do not put leaking batteries in an e-Media bin.
More than 5 pounds, large or leaking batteries: Submit a Chemical Waste Collection Request for EH&S pickup. Place leaking batteries in a plastic bag or container, wear gloves and wash your hands after handling.

Contact Environmental Programs with questions about large volumes or damaged batteries.

Most overhead lighting at UW locations is done by low mercury fluorescent light tubes (FLTs). Fluorescent lamps have many advantages, but they contain a small amount of mercury. Handle lamps carefully and never place any lamp, whole or broken, in the trash.

If a fluorescent light tube burns out, do not change it yourself. On the Seattle campus, request a lamp change from UW Facilities. At other locations, contact your local facilities or maintenance department. They will replace the bulb and recycle it for you.

If the lamps are broken, they must be disposed of as hazardous waste.

For more information on recycling fluorescent lamps, please visit Facilities Services’ Fluorescent Lamps Recycling page.

EH&S accepts motor oil and all other oils from laboratories and small equipment. Most of the non-halogenated oils are blended and recycled for use as bunker fuel on ships. Halogenated oils are incinerated.

To recycle oil, fill out the online Chemical Waste Collection Request.
If you generate waste oil on a regular basis, fill out New Routine Chemical Collection Request.

We also accept vacuum pump oil. However, check with your vacuum pump's manufacturer; some manufacturers accept your used vacuum pump oil and offer you a discount on your new oil in return.

Additional resources

Visit the Hazardous Material Disposal and Recycling page for more information about disposal, recycling, and sending to surplus additional types of hazardous materials.